adjusting the carb..

[acidburn]

i got my bike timed again, but it wont start cause of the carb i believe cause that was the last peice i messed with.(i pull over it does nothing, i pull over with full open throttle it starts n dies) so i was just wondering how to set it properly my bike is a atc200.
the lil flat head screw on the bottom outside is turned all the way right so the pin inside is sticking out.. and the one in the middle of the carb is screwed on all the way...


help this bike has been sitting for atleast a good 3months i changed the gas,plug etc

[acidburn]

one of my posts can be deleted i lagged n double posted

[MonroeMike]

You can delete it yourself.

[acidburn]

oh ok done.

anyways iv been looking thru the service manual hopping to find some help but all it helps with is idle speed... lol

[Lukeatc185]

is it a new carb? or freshly rebuilt? because it can be a guessing game setting a carb if its not clean.

[acidburn]

carbs clean but not new, i found some new news about the pilot screw it says its to be set 1 3/4 but what about my main jet and slow jet... i cannot find the settings for those

[ceaserthethird]

Do you have a Honda OEM Service Manual ? ? ?

[ceaserthethird]

what year is it ?

ATC 200X or ? ? ?

[Dirtcrasher]

There is no setting for the main and pilot, the needle should be in the center clip. The airscrew can be played with by 1/4 turn at a pop.

Are you sure the main jet and pilot jet have been removed and cleaned spotless??

[MonroeMike]

You have a 81 200 right? This is from the manual.